Burnham RTC (Return Temperature Control) Manual de instalación descargar pdf (Pagina 36)

36 of 60

A6. 4-way RTC in Primary/Secondary - Heating and DHW using Tankless Coil; with/without Outdoor Reset

(Mechanical)

120 V (ac)

24 V (ac)

Class II

Transformer

RTC

Outdoor Sensor

(S3) 070

Boiler Return

Sensor

(S1) 071

4D Max

COLD

Water

HOT

Water

OUT

ST1

A1 = Tankless Coil or Storage Tank Aquastat

C1 = Mixing Valve Actuating Motor

M1 = By-Pass Mix Point

P1 = Boiler Circulator

P2 = Tankless System Circulator

P3 = System Pump (runs on call for heat)

R1 = Relay (Required with and without priority)

R2 = Relay (Required for Priority)

S1 = Boiler Return Sensor

S2 = System Mix Sensor 071

S3 = Outdoor Sensor 070

ST1= Storage Tank

TK1= Tankless Coil

V1 = 4-Way Diverting Valve

V2 = Ball Valve, Balancing Valve

Z1...Z3 = Zones

NOTES:

1) Install the boiler as indicated above for systems where return temperatures may be less than 135F and heating/DHW

with tankless coils..

2) The Outdoor Sensor (S3) and the Mix Supply Sensor (S2) are required when the Outdoor Reset feature is selected.

The mix sensor must be installed 10 pipe diameters downstream of the system pump, in the primary loop. The mix sensor

must be secured to the surface of the pipe using a wire tie or similar device.

3) The by-pass piping, diverting valve and boiler circulator must be sized using the sizing charts found in Appendix B.

4) Closely spaced tees must connect the branch to the larger header. The Tee centerlines must be no greater than 4

times the larger header pipe diameter.

5) The diverting valve, V1, must be no greater than 11 linear feet of pipe from the Return Sensor, S1.

6) There shall be a MINIMUM of 4 linear feet of pipe between the By-pass Mix Point, M1, and the Return Sensor, S1.

7) The balancing valve in the boiler return line, V2, may be necessary in low head by-pass loop applications.

8) Domestic Hot Water must be tempered for safe usage. The tankless aquastat and/or storage tank aquastat (A1) are

normally closed switches. Circuit breaks on temperature rise.

9) Expansion tanks, air scoops and other components left out for clarity.

10) Observe all applicable plumbing and electrical codes.

This diagram is for reference only. The installer or designer is responsible for the proper selection and design

of the system.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 59 60

Comentarios a estos manuales

Sin comentarios

Burnham RTC (Return Temperature Control) Manual de instalación Pagina 36

Comentarios a estos manuales

Relacionado con productos y manuales para No Burnham RTC (Return Temperature Control)